Stamped IC sockets
Please note these are 0.3″ in width they suit a particular type of DIL chip (older TTL CMOS DIP ram etc.) not suitable for 0.6″ (eproms processors etc.)
Mounting: Through Hole
Number of Rows: 2
Contact Style: Twin swipe
Mounting Style: Straight
Termination Type: Through hole PCB mount
Housing Profile: Low
Device Type: Used On DIP16 0.3″ chips
0.3″ between the 2 rows of 8 tinned pins
Overall dimensions 20mm long x 10mm wide
Supplied in an open frame design.
General Specifications. Unless stated all values are typical.
Resistance: 10m ohms
Current Rating: 10 amp cont. 2.0 amp peak.
Plating: W3100TRC Nickel 2.5 microns over Pure Tin 6.0 microns
Insertion Force: 120/130 grams (1.18/1.27n) per pin 0.01” diameter.
Withdrawal Force: 50/70 grams (0.49/0.69n) per pin 0.01” diameter.
Point of contact: 0.061” (1.70mm) from top of socket.
Force to remove From moulding: 1.0lb minimum
Moulding: Material: Glass-reinforced Polyester (PBT)
Insulation Resistance: 1010 Ohms (contact to contact) at 500VDC
THESE PARTS CAME TO US AS PART OF A “JOB LOT” OF SURPLUS STOCK ORIGINATING FROM A LARGE MILSPEC TYPE CO.
THEY ARE NOT DATE CODED BUT WE KNOW THEY HAVE BEEN IN STORAGE FOR SOME YEARS WE HAVE THEREFORE CLASSIFIED THEM AS NEW OTHER.