IP67 Sealed ABS Junction Box Electronic etc. 73x80x53mm BB1 TG1 OLU1-02 OLU1-03


SKU: OLU1-02 OLU1-03 Category:


IP67 Sealed ABS Plastic Junction Box 

TG1 = Grey/Clear Lid 

BB1= Black/Black Lid 

Suitable for Housing Electronic Circuits/Projects

IP (or “Ingress Protection”) ratings are defined in international standard EN 60529 (British BS EN 60529:1992, European IEC 60509:1989).

 They are used to define levels of sealing effectiveness of electrical enclosures against intrusion from foreign bodies (tools, dirt etc) and moisture.

IP 67 Enclosures – IP rated as “dust tight” and protected against immersion.

They have a thick toughened wall design with integral seals and two knock out threaded holes at each end to accept cable glands, approx 20mm diam.

 The seal between base and lid is achieved by means of an all round tongue and grove type system, the grove in the lid is fitted with a rubber sealing ring when the lid is screwed down the tongue on the base compresses in to the rubber to seal the box. 

The screw down lid is retained by 4 recessed crosspoint screws.

Dimensions Size 73m long x 80mm wide x 53mm deep.

FEATURESSealed to IP67Complete with M20 cable knockoutsCaptive plastic screws in lidSuitable for enclosing printed circuit boards – vertically (via mounting slots) or horizontally
Temperature rating of -10° to +65°

SPECIFICATIONProduct TypeStandard baseNumber of Holes0Base ColourBlack or GreyLid ColourBlack or clearEnclosure MaterialABS-UL94-HBIP Rating67Max Temperature °C65Height (mm)80Width (mm)73Depth (mm)53

We were recently asked the following question:- 

“Hey, I want to fit a camera inside this, Is this clear enough to not blur the image?”

This can be done without significant loss of clarity, we have included a photograph above taken through the lid of the box (see knife and ruler pic above) 

Additional information